The inside is lined with a soft material to resist scratching.
To install the case, simply snap it on the iPhone. I did one edge at a time.
I noticed the edges of the case are covered in some kind of rubbery material that feels like it was brushed or dipped on. It’s not 100% even, but you probably won’t notice it.
I did notice two things I didn’t like. First, the sides of the case don’t reach the screen’s edge. That is, you’ll have a little exposed corner (see pointer in the following image). This is the same on all four corners. If you’re prone to dropping your iPhone 5, you may ding that bit.
Second, the case doesn’t really “snap” into place. It’s more of a friction fit. It wasn’t hard to shift the iPhone 5 slightly out of the case, as you’ll see in the following image.
The silver color really matched the white iPhone 5. I loved how it looked. I also noticed some very slight signal degradation (one bar lower) when the case was on, but I couldn’t duplicate the effect all the time. The exposed corner and slightly loose fit were dealbreakers for me. Too bad, because I love how the Gasket V8 looks!